Panasonic CF-72 Supplementary Instructions Manual page 4

Supplementary Instructions
4
5
Press [Have Disk]
6
Input [c:\util\drivers\clan] and then press [OK]
7
Select [Intel(R) PRO Adapter] and then press [OK]
<When the settings for the modem have already been made>
1 Select [Intel(R) PRO Adapter] and then press [OK]
2 Select your protocol and network service (etc.).
3 Press [Close] and follow the on-screen instructions, then proceed to step 12.
8
Press [Next]
9
Select your protocol and then press [Next]
10
Select your network service and then press [Next]
11
Press [Next]
12
Input [c:\winnt\i386] and then press [Continue]
<When the settings for the modem have already been made>
Perform this procedure only when the screen to insert the Windows NT CD is
displayed.
Follow the on-screen instructions.
The settings will vary for different network environments depending on the network
system being used. For more details, ask your system administrator or the person in
charge of the network.
13
In [Start] - [Run], input [c:\sp6\sp6i386.exe], then press [OK]
Follow the on-screen instructions.
NOTE
Do not use standby or hibernation functions during communications.
Unable to connect to network (When the indicator of your HUB unit does not light):
Windows 98
1 Select [Network] in [Start] - [Settings] - [Control Panel].
2 Select [Intel 8255x-based PCI Ethernet Adapter (10/100)].
3 Select [Properties].
4 Select [Advanced].
5 Select [Link Speed & Duplex] from [Property], set [Value] to the communication
speed (10 Mbps or 100 Mbps) suitable for your network environment, and then press
[OK].
Windows NT
1 Select [Adapters] in [Start] - [Settings] - [Control Panel] - [Network].
2 Select [Intel 8255x-based PCI Ethernet Adapter (10/100)].
3 Select [Properties] - [Advanced].
4 Select [Link Speed & Duplex] from [Setting], set [Value] to the communication speed
(10 Mbps or 100 Mbps) suitable for your network environment, and then press [OK].
Windows 2000
1 Select [Device Manager] in [Start] - [Settings] - [Control Panel] - [System] - [Hard-
ware].
2 Select [Intel 8255x-based PCI Ethernet Adapter (10/100)] from [Network adapters].
3 Select [Action] - [Properties].
4 Select [Advanced].
5 Select [Link Speed & Duplex] from [Property], and set [Value] to the communication
speed (10 Mbps or 100 Mbps) suitable for your network environment, and then press
[OK].