Garden Architecture HERITAGE PERGOLA ARBOR Assembly Instructions

Garden Architecture HERITAGE PERGOLA ARBOR Assembly Instructions

Advertisement

Quick Links

HARDWARE LIST

A
B
C
D

PARTS LIST

1
Header
Side Panel
3
2
.
.
.
1

TOOLS REQUIRED

Power screwdriver or drill
Tape measure
Handy to have:
Level
Carpenter's square
Stool or short ladder
Bit holder may be needed if using a drill with a
quick-change chuck
Product ID 820.2170 / Instruction ID 445.35.30
Bowers Forest Products / PO Box 589 / Beavercreek, OR 97004 / Cust. Serv. 503-631-4408
ASSEMBLY INSTRUCTIONS
HERITAGE PERGOLA ARBOR
REVIEW ALL STEPS BEFORE STARTING ASSEMBLY
Quantity
1¼" Screw
(30)
2½" Screw
(4)
Drill bit (if other than
Phillips head)
Spacer block
2
Brace
Cap
4
4
.
3
3

PRELIMINARIES

Selecting a Work Area
Select an area close to where the arbor will be installed.
The assembly area should be relatively flat and open, at
least 9'x7'. A lawn, driveway or wide path will be
satisfactory. It is a good idea to lay out the arbor box on
your work surface to protect the arbor from nicks and
scratches. Two people are required for the assembly
process. Always use caution when assembling or moving
the arbor.
Optional Painting or Staining
If you wish to stain or paint your arbor, we recommend
applying to individual components before assembly to
ensure fullest coverage. Use a high quality exterior stain or
paint. Be careful not to cover up guide marks on arches.

ASSEMBLED PRODUCT

HA
.
Updated 11/19/19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HERITAGE PERGOLA ARBOR and is the answer not in the manual?

Questions and answers

Summary of Contents for Garden Architecture HERITAGE PERGOLA ARBOR

  • Page 1 ASSEMBLY INSTRUCTIONS HERITAGE PERGOLA ARBOR REVIEW ALL STEPS BEFORE STARTING ASSEMBLY HARDWARE LIST PRELIMINARIES Selecting a Work Area Quantity Select an area close to where the arbor will be installed. The assembly area should be relatively flat and open, at 1¼”...
  • Page 2 GARDEN STRUCTURES ASSEMBLY INSTRUCTIONS HERITAGE PERGOLA ARBOR STEP 1 Pencil mark • Lay one of the side panels flat on your work surface, aligning one brace to the pencil mark on the post. • Using one 2½ screw, secure the brace into the side panel, flush with outer edge of post.
  • Page 3 GARDEN STRUCTURES ASSEMBLY INSTRUCTIONS HERITAGE PERGOLA ARBOR STEP 3 • Carefully raise and square up the arbor. This can be easily done with a large carpenter’s square, a tape meas- ure, or even a length of string, as shown below.
  • Page 4 GARDEN STRUCTURES ASSEMBLY INSTRUCTIONS HERITAGE PERGOLA ARBOR ANCHORING THE ARBOR Securing the arbor is recommended. This item may be secured using a variety of techniques, including: Anchoring permanently with concrete. • Anchoring with sand or gravel. • Anchoring directly into the ground.

Table of Contents