Garden Architecture Summer Haven Assembly Instructions Manual

CHECK THE BOX FOR THESE CONTENTS
Right side panel (1)
1
Left side panel (1)
2
3
Bench (1)
4 Back panel (1)
5 Gable (2)
6
Top panel (2)
HARDWARE
A. 3" Screws (4)
B. 2 1/2" Screws (8)
C. 2" Screws (16)
D. 3/8" Dowels (4)
TOOLS YOU WILL NEED
• •
Phillips screwdriver
HANDY TO HAVE
•
Power screwdriver
•
Step ladder
• Quick clamps (2)
• Wood glue
PRELIMINARIES
IF YOU PLAN TO PAINT:
If you wish to change the stain color or paint your arbor, we recommend that you do so before assembly, it will make
the job easier. Be careful not to cover up guide marks on gables.
WORK AREA
Select an area close to where the arbor will be finally placed. The area should be relatively flat and open, at least 10'x20'.
Garden Architecture is a division of LWO Corporation / PO box 17125 / Portland, Oregon / 97217
Customer Service 1-800-459-8718 / Fax 1-888-283-7661 / Email info@lwocorp.com / Website www.lwocorp.com
Page 1 of 3
ASSEMBLY INSTRUCTIONS
Summer Haven Arbor
PLEASE READ THROUGH BEFORE STARTING ASSEMBLY
ASSEMBLED ARBOR
5
1
445.35.58
6
4
3
Seat installation shown. Bench may alternatively
be installed in higher position as a workbench.
SH
2
Updated September 27, 2010