Advertisement
Installation - Talos
Talos
TM
The four-pin CPI Synq
Synq cable's four-pin male connector, and connect the Synq's MDB cable to the Talos' Female MDB cable.
Installation - Gryphon
Gryphon with a pre-installed Synq cable
If there is a four-pin male Synq cable pre-installed on the Gryphon, simply connect the Synq's female cable to Gryphon's
pre-installed male cable, then connect the Gryphon's Male MDB cable to the Female MDB port on the back of the Synq
and skip to the next section.
Gryphon without a pre-installed Synq cable
If there is not a Synq cable pre-installed on the Gryphon, it will be necessary to order one and connect it to the PCB as
follows:
Lift up on the yellow tab and pull
the Acceptor Module forward
Once the cable is installed on the Gryphon, connect it to the Synq's four pin female port, and connect the Gryphon's MDB
cable to the female MDB port on the back of the Synq.
Bill Validator
™
port is the top port on the left side of the validator, just above the 30-pin connector. Connect the
Coin Changer
™
Press down on this tab to
remove the PCB Cover
Connect the cable to this port.
When complete, re-cover the PCB
and close the Acceptor Module
Advertisement
