CSS MicroSystems AMAneo USB Manual

AMAneo

Introduction

The Assistive Mouse Adapter AMAneo
control a computer mouse more easily by filtering out shaky hand movements.
Just plug this device into any PC or Notebook for smoother control. It can be
adjusted to compensate tremors of varying intensities. A dwell function is
integrated as well as a movement stop while clicking.

Main features

• USB interface for Windows, MAC, Android
• Adjustable tremor compensation
• Adjustable Click Timer
• Adjustable Button Delay
• 2 Connectors for external switches
• Special functions: Deactivating or grouping of the mouse keys

How to connect

Please use the included USB cable to connect AMAneo
Connect the mini USB plug of the cable to the "USB PC" port.
The port "USB" is to be used to connect your mouse. You can use any mouse
like standard mice or assistive mice like head or mouth controlled mice. Wireless
mice can be used also, just plug in the USB dongle.
Only Bluetooth mice cannot be used. It's not possible to connect a Bluetooth
dongle.
If you like to use separate switches for left and right mouse button, please
connect a button for left click to "S1" and for the right button to "S2".
You don't need any driver or other software components. After connecting you are ready to go.

Adjustments

There are three buttons on top of the case. The Select button is to switch between the three adjustment
modes explained below, the "+" and "-" button are to adjust every option.
Select LED: if the light is green, AMAneo
Tremor:
If you press the Select button once (less than 3 sec.) the light will switch to blue. Now you can adjust the
tremor filter by pressing the "+" and "-" button from low to high filtering indicated at the green bar in 10
steps. No light in the bar means no filtering. 10 lights are the highest level.
To go back in working mode, just press the Select button again three times to be back on green light.
Button delay:
If you press the Select button twice (less than 3 sec.) the light will switch to red. Now you can adjust the
delay of the mouse buttons by pressing the "+" and "-" button. They will now react only after a certain
time. No light in the bar means no delay. To go back in working mode, just press the Select button again
twice to be back on green light. Please note: If you want to use the Button Delay for the mouse buttons,
make sure that the Click Timer is set to zero (no green bar).
If the Click Timer is activated (not zero), the Button Delay has a different function! For the Click Timer the
button Delay sets the tolerance (means: the field size in which you can move to trigger an automatic
click). For a good function usually 2 (2 of 10 green LEDs) is sufficient.
Click Timer:
Click timer means that the left mouse button will automatically be activated if you let the mouse stay at
the same point for a defined time (dwell function). If you press the Select button three times (less than 3
sec.) the light will switch to yellow. Now you can adjust the Click Timer by pressing the "+" and "-" button.
No light in the bar means no dwell function. To go back in working mode, just press the Select button
again once to be back on green light. The tolerance (means: the field size in which I can move to trigger
an automatic click) can be adjusted with the "Button Delay" function. Further information at "Button
Delay".
Function off:
If you press the Select button for more than 4 seconds (less than 6 seconds) the light goes to pink and all
filtering and delays are off (normal mouse use). To switch it on again, just press the Select button again 4
to 6 seconds.
Manual AMAneo 1.03 en.odt
USB
helps people with hand tremors
USB
USB
is working.
USB
to your computer.
Vers.1.03