Advertisement
BATTERY INSTALLATION
1. Installing batteries:
a. To install new batteries, remove the top cover (1) of the
pump (A) by turning the handle counterclockwise.
b. Remove the battery compartment (2).
c. Insert three alkaline "D" cell batteries (3; not included) in
position as indicated on the battery compartment (2).
d. Replace the battery compartment (2) and lock the top
cover (1) back on top of the pump (A) by turning
clockwise.
Note: Lubricate the black O-ring (4) at the top of the pump (A)
with petroleum jelly (sold separately) to make it easier to put
the cover (1) back on.
OPERATING INSTRUCTIONS
CAUTION: Do not run the pump dry. Operating the pump without water will cause damage to
seals and will cause the pump to fail, thereby voiding the pump's warranty.
Notice: Make certain you unwind the hose (1)
completely. Kinks in the hose will restrict the pump,
preventing it from priming, which is the first step to
pumping water. The water level must be at 1-1/4 in. for
the pump to prime and operate.
1. Place the pump (A) in the water you wish to pump
out and position the hose (1) so that it is free of
kinks. Ensure the pump (A) is in an area that is
free from debris to prevent clogging.
CAUTION: T o avoid airlock (flow stoppage), place
the pump in water before turning on. If the pump must
be turned on before being submerged, it may take 10 -
30 seconds for the water to begin to flow (allowing the
pump to clear airlock).
Note: If you want the pump (A) to float, remove the filter screen (2) on the bottom of the pump.
The pump will then float in an upright position. This is ideal for pumping water out of an area that
has debris at the bottom or areas where the depth to be pumped is longer than the hose length.
Note: The maximum discharge height (head) is 36 in. (3 ft.).
2
Advertisement
