Leds - Fortinet FortiController-5913C System Manual

FortiController-5913C system

LEDs

FortiController-5913C Session-Aware Load Balancing Cluster (SLBC) System Guide
10-500-259409-20160210
http://docs.fortinet.com/
Table 1: FortiController-5913C LEDs
LED State
Off
OOS
Amber
(Out of Service)
PWR (Power) Green
Off
Flashing
STA (Status)
Green
Amber
F1 and F2 Flashing
Amber
Off
Green
B1 and B2 Flashing
Green
Off
Link/Act Solid
(Left Green
LED)
Blinking
Green
MGMT
Off
Speed Green
(Right
Amber
LED)
Off
Blue
Flashing
IPM
Blue
Off
Description
Normal operation.
A fault condition exists and the FortiController-5913C
blade is out of service (OOS). This LED may also flash
very briefly during normal startup.
The FortiController-5913C is powered on.
The FortiController-5913C is powered on.
The FortiController-5913C is starting up. If this LED is
flashing at any time other than system startup, a fault
condition may exist.
The correct cable is connected to the interface and the
connected equipment has power.
Network activity.
No link is established.
The correct cable is connected to the interface and the
connected equipment has power.
Network activity at the interface.
No link is established.
Indicates this interface is connected with the correct
cable and the attached network device has power.
Indicates network traffic on this interface.
No Link
Connection at 1 Gbps.
Connection at 100 Mbps.
Connection at 10 Mbps.
The FortiController-5913C is ready to be hot-swapped
(removed from the chassis). If the IPM light is blue and no
other LEDs are lit the FortiController-5913C has lost
power
The FortiController-5913C is changing from hot swap to
running mode or from running mode to hot swap. This
happens when the FortiController-5913C is starting up or
shutting down.
Normal operation. The FortiController-5913C is in contact
with the chassis backplane.
Front panel LEDs and connectors
7