Table of Contents
Advertisement
Shutting down and Removing a FortiController-5913C board
18
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
FortiController-5913C boards must be protected from static discharge and physical
shock. Only handle or work with FortiController-5913C boards at a static-free
workstation. Always wear a grounded electrostatic discharge (ESD) preventive wrist
strap when handling FortiController-5913C boards.
1 Attach the ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2 Disconnect all cables from the FortiController-5913C board, including all network
cables and the console cable.
3 Fully loosen the FortiController-5913C retention screws.
Loosen
4 Unlock the handles by squeezing the handle locks.
5 Slowly open both handles a small amount (about 8 degrees) until the IPM LED flashes
blue.
6 Keep the handles in this position until the IPM LED stops flashing and becomes solid
blue.
Waiting for the IPM LED to change to solid blue makes sure that the board software
shutdowns completely before disconnecting it from backplane power.
7 Open the handles to their fully open positions.
To avoid damaging the lock, make sure you squeeze the handles fully to unlock them
before opening. The handles should pop easily out of the board front panel.
Opening the handles turns off the microswitch, turns off all LEDs, and ejects the board
from the chassis slot. You need to use moderate pressure on the handles to eject the
board.
Alignment Pin
Handle
Open
Lock
8 Pull the board about half way out.
FortiController-5913C Session-Aware Load Balancing Cluster (SLBC) System Guide
Retention
Screw
Hardware installation
Alignment Pin
Handle
10-500-259409-20160210
http://docs.fortinet.com/
Advertisement
Table of Contents
