Advertisement
Operation
Using the Jack Mount
WARNING
The machine could fall onto someone and
cause serious injury or death.
• Do not keep the machine raised on the jack
for extended periods of time.
• Always use a jack on a level surface.
• Ensure that the jack is secured properly to
the jack mount using a jack pin.
• Do not rely solely on the jack for support.
Use adequate jack stands or equivalent
support.
• Do not mount or dismount the mower while
the jack is raised.
• Before each use, ensure that the jack and
jack mount work properly and that there
are no signs of damage.
Note:
Use only a manufacturer-approved jack rated
at 907 kg (2,000 lb) or higher lift capacity with the
jack mount.
1.
Park the machine on a level surface,
disengage the blade-control switch, move the
motion-control levers outward to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Attach the jack to the jack mount with a jack pin
(Figure
2).
1. Jack mount
2. Jack pin
4.
Use the jack to raise the machine to the desired
height.
Raising the machine could cause a fuel
leak. Fuel is extremely flammable and
highly explosive.
• Check for any fuel leaks before
EUTRAL
• If you see a fuel leak, immediately
5.
Support the machine with jack stands; refer to
the machine Operator's Manual for jack stand
placement.
6.
When finished, use the jack to lower the
machine, then remove the jack.
Note:
attached.
2
Figure 2
3. Jack tube
4. Jack
WARNING
performing maintenance.
lower the machine, drain the fuel, and
wipe up the spill.
Do not operate the machine with the jack
g202641
Advertisement
