« ¨ Thank you for buying ALIGN Products. The M424 V2 Quadcopter is designed as an easy to use, full featured M424 V2 Quadcopter R/C model capable of all forms of rotary flight. Please read the manual carefully before assembling the model, and follow all precautions and recommendations located within the manual.
Page 4
FORBIDDEN PREVENT MOISTURE »Â¼ÀÀ¹ ¸ ¤ R/C models are composed of many precision electrical components. It is critical to keep the model and associated equipment away from moisture and other contaminants. The introduction or exposure to water or moisture in any form can cause the model to malfunction resulting in melfunction, or a crash.
Page 6
¦ ³ ¦ ¹ ¥¦ º 6.PARTS LIST More parts information and specification please refer to Parts Quick Finder at Align Cart. http://shop.align.com.tw/partfinder.php §¦¬Ã¹¥¡³®¡½°¾ ALIGN Cart ¡ Rotor blade (counter rotation)- Fluorescent orange ±Á(L)-¾ aluminum rotational shaft Rotor blade ¾Â¶...
» ±¾ ¹ ¦ ¦ ¸ 9.TRANSMITTER BATTERY INSTALLATION CAUTION STEP 1 ª · 1. The included AA batteries are rechargeable Ni-MH batteries, capable of multiple recharge cycles. 2. When the transmitter batteries are depleted, LCD display will show TX , and transmitter will emit warning tone.
Page 10
LED INDICATOR LEDª¥ Green ¬¿ º¿ Idle and Charge Completion Charging «¾ªº»¥¹§¦ ¥¹¤ CHARGER SPECIFICATIONS CH240¥¹¾³® Input Charging Current Full Voltage ¿¤ ¥¹¹¬ ¥¹¹À 530mA x1 sets DC 5V 1A ² 4.2¡0.03V ¤¦ ¤ METHOD 2 CAUTION Polarity of Mini USB of the charger ª...
CHARGING METHOD FOR TRANSMITTER'S NI-MH BATTERIES »±¾Â²¹¦ª¥¹¤¦ ¤¦ ¤ ¤¦ ¤ METHOD 1 METHOD 2 AT100 transmitter is capable of charging its internal AA Ni-MH batteries. Please ensure the AA batteries in the transmitter are rechargeable before attempting to charge. After connecting the transmitter as shown in diagram, power up transmitter, TX will be...
12.SWITCHING BETWEEN MODE 1/MODE 2/MODE 3 ON TRANSMITTER »±¾MODE 1 / MODE 2 / MODE 3 ª¤´ MODE1 is commonly used in Asia where throttle stick is on the right hand side, where MODE2 (throttle stick on left side) is more common amongst western countries.
SWITCHING BETWEEN MODE1 AND MODE2 MODE 1 »MODE 2 ª¤´¤¦ Loosen up the 8 screws holding the two control sticks, and swap the control sticks to change between MODE1 and MODE2. 叫盢北 膘:8聋脸捣肞秨 ユ传北 膘家舱 ち 传 MODE 1 の MODE 2 :巨 家Α...
Page 16
When testing the function of Quadcopter, hold the copter firmly, do not exceed half throttle, always keep copter away from your face / head. ´¸¥¶ ¦¾¦ °§®¡¤°¥ §¦¾¤¡ªª¤¯¶¹¤¥¡¥±¾¤»ÂÀ³¡ CAUTION ª · During testing, throttle stick need to be in the middle, do not exceed 50% output position on the pitch curve.
STEP 5 ¨Æ5 Remove the quadcopter battery safely at the conclusion of flight. This should be made into a post flight habit to avoid unforeseeable problems. µ§ ¦®¡½±¥¶ ¦¾¹¦¦¥¨¤¡½¾¦ ¨¦²º¡¥§³¦¿¾¡ WARNING Ä § Warning: If left connected in the helicopter for long duration, the battery may be Li-Polymer battery damaged due to over- discharge, or even...
Page 20
1STEP THROTTLE CONTROL PRACTICE ªª±¨½² Mode 1 Mode 2 ¡ When the quadcopter begins to lift-off the ground, slowly reduce the throttle to bring the quadcopter back down. Keep practicing this action until you control the throttle smoothly. ¡ ·¥¶ ¦¾Â¦« ºº §ªª±¥¶ ¦¾ ¤ ¡...
ADJUSTMENT OF EACH TRIM ¦°§·½ Slowly raise the throttle stick and just as the helicopter lift-off the ground,you can use the trim to correct the action if the quadcopter leans in a different direction. ºº¤°ªª·±¡·¥¶¦¾Â¶¦®¡ªª¾¶¦¤¦¤¦¡¥¨¥·½¥°§¡ Adjustment of rudder trim ½¾¤¦²·½ Right ¥±...
Need help?
Do you have a question about the Super Combo M424 Quadcopter V2 and is the answer not in the manual?
Questions and answers