V 0.1 8825762 880 Lb 24V Electric Flat Cart Owners Manual Table of Contents Specifications …………………… Operating ………………………… Safety ………………………………. Parts List …………………………… Assembly …………………………. Please read and understand all instructions before use. Retain this manual for future reference.
V 0.1 8825762 SAFETY WARNING! Read and understand all instructions before using this device. The operator must follow basic precautions to reduce the risk of personal injury and/or damage to the equipment. Keep this manual for safety warnings, precautions, operating or inspection and maintenance instructions.
Page 4
V 0.1 8825762 SAFETY (cont’d) 11. Do not load items on the top edges of the carrier deck rails. Remove the rail tubes before loading oversized items. 12. Distribute the load evenly over the surface of the carrier deck and use a tiedown when appropriate.
Page 5
V 0.1 8825762 PRE-OPERATION SAFETY (Cont’d) Thoroughly inspect the area to be worked, keep the working area clean and free of debris to prevent tripping. Operate on a flat level ground. Never place any part of your body where it would be in danger if movement should occur during assembly, installation, and operation, maintenance, repairing or moving.
V 0.1 8825762 ASSEMBLY Front Frame Front Wheel Disc Brake Front Carrier Deck Plate Drive Unit Brake Caliper Rear Frame Drive Lever Front Carrier Rail Tube Rear Carrier Deck Plate Rear Caster Wheel Right and Left Carrier Rail Tubes Throttle/Right Handle...
Page 7
V 0.1 8825762 ASSEMBLY (Cont’d) The cart and its parts are wrapped in bubble wrap and packaged in a corrugated box for shipment. Use a sharp object to cut through the tape on the top of the box while taking care not to cut too deep as this may scratch the powder coated parts, polished carrier deck, or cut through loose brake or electrical cables.
V 0.1 8825762 OPERATING READ AND UNDERSTAND ALL WARNINGS BEFORE OPERATING THIS EQUIPMENT. This cart is not a toy. Do not permit children to operate this machine at any time. Introduction Brake Lever Brake Lever – The brake lever is located on the left handle bar.
Page 9
V 0.1 8825762 OPERATING (Cont’d) Loading the Carrier Deck – When loading the carrier deck, ensure the load is evenly distributed and centered. Failure to center the load may cause the machine to be unbalanced and may tip over. The carrier frames are there to help prevent a load from shifting.
Page 10
V 0.1 8825762 OPERATING (Cont’d) Handle Adjustments – The handles may be adjusted for Handle Rotation comfort. The handles may be rotated to a storage position as shown in order to save space, they may also be rotated outwards to a comfortable position for the operator.
Page 11
V 0.1 8825762 OPERATING (Cont’d) Drive Motor Reduction Gearbox Drivetrain – The drivetrain consists of a DC powered Drive Motor Power Cable Differential drive motor, a speed reduction gearbox, and a Drive Actuator Cable differential gear. This system is adjusted at the factory and should not need repair or adjustment.
Page 12
V 0.1 8825762 OPERATING (Cont’d) Charge Indicator Light Charger – The charger operates with an input voltage between 100VAC and 240VAC, and either 50 or 60 Hz without needing to adjust. Its output is 29VDC, 3.5A. The charger should not be used to charge other products.
V 0.1 8825762 PARTS LIST PARTS LIST (Refer to the parts drawing earlier in this manual) Always use original replacement parts Item Item Name Part Number Quantity Number ① Front Frame ZH4-013 ② Front Carrier Deck Plate ZH4-013-1 ③ Rear Frame ZH4-014 ④...
Need help?
Do you have a question about the 8825762 and is the answer not in the manual?
Questions and answers