Introduction; Safety Instructions - Sinclair SAI-01 User Manual

INTRODUCTION

The SAI-01 interface unit indicates the state of the FOCUS PLUS wall-mounted air conditioner (ASH-
09BIF2, ASH-13BIF2, ASH-18BIF2, ASH-24BIF2) by monitoring the communication between the indoor
and outdoor air conditioner units. The interface unit indicates the state by flashing the LEDs and
switching the relays. According to the settings, the indicated states can be: errors, limitations and
general errors of the A/C system, additionally switched-on system, compressor running, cooling
activated.

SAFETY INSTRUCTIONS

WARNING
Please read this manual carefully before installing this device!
This manual is a part of the product and must be kept near the device to be available for easy

reference.
This device is not intended to be used for other purposes than those described below.

Before starting operation, please check the range of operating conditions of the given

installation.
The SAI-01 alarm interface unit may be installed only by a company that has the relevant

qualification and is authorized by the manufacturer.
This device is designed for mounting on a DIN rail in a dry and dust-free environment. Do not

allow the water to get into the electrical components; there is a risk of electric shock or
damage to the unit.
Do not allow persons without the necessary qualification, and especially children, to

manipulate the device.
Cleaning and maintenance may only be performed by persons with a suitable qualification.

Otherwise, personal injury or property damage may occur. Do not dismantle or repair the
device.
Disconnect the device from the power supply before cleaning or maintenance. Otherwise, an

electric shock may occur.
Do not touch the device with wet hands, do not operate it in a wet environment and do not

wash it with water. There is a risk of electric shock.
Damaged power cables must be replaced by the manufacturer, authorized service centre or

appropriately qualified person.
Do not repair the device yourself. Otherwise, electric shock or damage to the device may

occur. Contact your dealer, if you need to repair the device.
Immediately turn off the device and disconnect it from the power supply, if any of the

following conditions occur. Then ask your dealer or an authorized service centre for repair. If
you let the device running under these conditions, this may cause a malfunction, electric
shock or fire.
The power cord is overheated or damaged.
•
• An abnormal noise during operation.
An upstream breaker repeatedly trips.
•
• The device smells like something is burning.
Ensure that the wires for sensors, load and power supply are led separately and far enough

from each other, without crossing or parallel leading.
Sinclair alarm interface unit SAI-01 2