, HydraFacial MD ™ , Vortex-Fusion ™ , HydroPeel ™ , Britenol ™ , HydraFacial MD CTGF ™ , UV Smart ™ , and My Life, Introduction My Time, My Skin ™ are trademarks of Edge Systems LLC that are registered in the United States. This product and its use are covered by one or more U.S.
Specification 220–240 VAC 110–120 VAC system designed in the USA by Edge Systems LLC. The HydraFacial System is a modular system which may include other modes of 70290-03-01 70143-03-01 operation not available in the EEA. Separate User Guides are provided for all optional modalities.
Safety Guidelines Product Marking Symbols Caution and Marking Symbols ™ 1. Ensure that all operators of the HydraFacial MD Elite ™ System are trained and licensed as required by local/national regulations. Do not operate the unit before being trained. For any questions regarding training, contact Edge Systems LLC or your...
IEC 61000-4-11:2004 ISO 7637-2 Portable RF communications equipment should be used no closer than 15 cm/6 in to any part of the HydraFacial System, including cables specified by Edge Systems LLC. Otherwise, degradation of the performance of this equipment could result.
HydraFacial Device Monitor) USB Type A Cable (Port can only be used to connect USB Type A Cable from inside HydraFacial Device 3.5 mm Jack Audio Cable to the HydraFacial Device Monitor) Note: The ports and cables can only be used for connections as specified...
HYDRAFACIAL MD ™ Elite ™ User Guide HYDRAFACIAL MD ™ Elite ™ User Guide Set-Up To remove the cartridge and insert skin solution vials (sold separately), twist the cartridge until the arrow aligns with the unlock symbol, then pull the cartridge straight out. Then insert the vial into the handpiece. Push firmly until it snaps into place.
The touchscreen has been preset for optimal performance with the HydraFacial program. Thus, you cannot and will not need to adjust the monitor. Access each page by lightly tapping the buttons displayed with your fingertip, not fingernail. If the touchscreen does not respond, verify that you have actually pressed on the button and did not miss it.
Make sure that the Rinseaway System Cleaning Solution is properly installed. Switch the toggle switch to “ON”. Note: Only use HydraFacial Rinseaway System Cleaning Solution to properly clean the handpiece. Turn the vacuum on and set to 26. Let the cleaning process run for 20–30 seconds.
HYDRAFACIAL MD ™ Elite ™ User Guide HYDRAFACIAL MD ™ Elite ™ User Guide HydraFacial Handpiece Waste Canister After Each Service The HydraFacial ™ handpiece tubing chambers must be cleaned and disinfected using the cleaning brush. Empty waste on the back of the unit. DO NOT let the waste canister fill above 450 mL.
Make sure your skin solution bottle is not empty. is leased back to and operated by the original Customer and any such leasing company has no greater rights than the original Make sure that your HydraFacial handpiece is properly connected to the side of the Customer.
Page 12
HYDRAFACIAL MD ™ Elite ™ User Guide Edge Systems LLC 2277 Redondo Ave. Signal Hill, CA 90755 USA (800) 603-4996 (562) 597-0102 • hydrafacial.com Designed in California, USA...
Need help?
Do you have a question about the MD Elite and is the answer not in the manual?
Questions and answers
Hydra facial elite is throwing up a CMOS Checksum error screen