Table of Contents
Advertisement
OPERATION
Before First Use
Carefully unpack your appliance and remove all accessories. Wash them in
warm, soapy water then rinse and dry with a dry towel. Carefully wipe the
exterior of the base if necessary.
WARNING: Do not immerse the appliance base in water or any other liquids.
Using the Electric Slicer & Grater
• Attach the Feed Chute to the Appliance Base. This is done by holding the
Feed Chute at a 45 degree angle to the right, inserting it in to the socket
on the Appliance Base, then rotating it 45 degrees back to the left so that
it is locked in to place in the upright position.
• Select a cone suitable for the slicing or grating task you require and t it
onto the star shaped drive mechanism at the back of the Feed Chute.
Rotate it slightly clockwise to hold it in place.
• Cut the ingredients into pieces that will t into the Feed Chute and place a
suitable container under the outlet.
• Connect the appliance to a suitable 220 -240V ~ 50Hz power outlet socket
• Press the ON/OFF button once or twice to ensure that the Cone has locked
into place and turns freely.
• Make sure that the Pusher has been removed from the Feed Chute, and
then insert the precut food through the top of the Feed Chute.
• Press and hold down the ON/OFF button to activate the motor then
slowly push the food down with the pusher. Do not exert too much
pressure on the pusher, as this could a ect the quality of the end result
and could even cause damage to the appliance.
• Turn o by releasing the ON/OFF button.
• To remove the cone unlock the Feed Chute by rotating it 45 degrees to the
right then lock it back into place by rotating 45 degrees back to the left.
The Cone can now be easily removed.
• Remember to unplug the unit from the power outlet when it is not in use,
changing parts or is left unattended.
• Always clean the product immediately after each use. Disassembly is
reversal of assembly instructions.
Important: This appliance is designed for short term operation only. Do not
run continuously for more than 2 minutes. After 2 minutes stop and rest for
1 minute to allow the appliance to cool.
Note: The rst time this appliance is used there may be a small amount of
smoke and odour. This is normal and is due to the protective coating placed
on the motor at manufacture to protect it during shipping.
Tip: For best results use rm ingredients. If the ingredients are too soft the
will clump together and accumulate in and around the cone. If the
ingredients are too hard the appliance and cones may become damaged.
5
www.PyleUSA.com
Advertisement
Table of Contents
