K. Turnbutton And Terminal Strip; Faceplate; Telephone); Designation Window (Ne-2500 Type Telephone) - NORTHERN ELECTRIC NE-500 Identification, Installation, And Maintenance

2. Remove the handhole cover mounting
screw.
3.
Slide out the handhole cover mounting.
4. Pull out the plunger(s).
~mbly
I. Insert the plunger(s). The right plunger is
the exclusion plunger when assembling from
within the housing.
2. Slide the handhole cover mounting into
position.
3. Insert the screw and tighten it to secure the
handhole cover mounting.
4. Replace the housing.
K. Turnbutton and Terminal Strip
Removal
I. Remove the housing per 6.01 A.
2. Detach the dial from the dial mounting per
6.01
D.
3. Disconnect the dial leads from the terminal
strip.
Note: Do
not disconnect the soldered
connections between the turnbutton and the
terminal strip.
4. Remove the two screws on the underside of
the telephone set base securing the
turnbutton to the base.
5. Remove the screw in the left arm of the dial
bracket.
6. Remove the retainer and the terminal strip.
~mbly
l. To assemble the turnbutton and terminal
strip, reverse the above procedure.
L.
Faceplate (NE-2500 Type Telephone)
Removal
l.
Insert the NS16750-L3 releaser into the
faceplate retaining spring clip notch (top
center of faceplate).
SECTION 502-5101-201
2. Move the retaining clip toward the housing
until the releaser can be pushed down
behind the upper edge of the faceplate.
3. Pry the faceplate forward with the releaser
until it clears the retaining clip.
4. Move the faceplate forward and lift out.
Assembly
1. Key the lower edge of the faceplate into the
housing opening.
2. Move the retaining clip toward the housing
using the NS 167 50-L3 releaser and seat the
faceplate in the housing.
3. Remove the releaser and the retaining clip
will spring back into position, locking the
faceplate in place.
M. Designation Window (NE-2500 Type
Telephone)
Removal
1.
Insert the NS l 6750-L3 releaser in the hole
of the plastic designation window.
2.
Pry the designation window until it bows
clear of the faceplate; then lift it out of
position.
3. Pull the designation window away from the
faceplate.
A~embly
1. Set the number card in the appropriate slot
on the faceplate.
2. Wedge the nonslotted end of the designation
window in the housing.
3. Bow the window until it can
slide into the
slot and lock in place.
Page 31
31 Pages