Apparatus Blank (Desk Telephones); Apparatus Blank (Wall Telephones) - NORTHERN ELECTRIC NE-500 Identification, Installation, And Maintenance

Assembly
1. Connect the dial leads as described in the
appropriate section.
2. .
Loosen, but do not remove , the two screws
on the sides of the dial.
3. Slide the dial screws into the slots on the
mounting bracket.
4. Position the dial so that the locating points
on the dial are seated in the corresponding
holes in the dial bracket.
5. Tighten the two dial screws.
6. Replace the housing.
E. Apparatus Blank (Desk Telephones)
Assembly
I. Remove the housing per 6.01 A.
2. Remove the dial per 6.01 D.
3. Mount the NE-95B apparatus blank with
the marking "FRONT" at the lower end of
the housing as shown in Fig. 5.
4. Rest the tip of the bracket in the opening in
the ridge encircling the dial cutout.
5. Fasten the two self-tapping screws to the
apparatus blank through the two holes on
the bracket.
6. Place the card holder parts group assembly
on the apparatus blank.
7. Rewire the telephone set for manual service
as described in the appropriate section on
telephone set connections.
8. Replace the housing.
SECTION 504-5101-201
Removal
I.
Remove the housing per 6.01 A or B.
2.
Remove the two screws securing the bracket
to the apparatus blank.
3. Install the dial referring to the applicable
section.
4. Replace the housing.
F
Apparatus Blank (Wall Telephones)
Assembly
I.
Remove the housing per 6.01 B.
2. Remove the dial per 6.01 D.
3. Rewire the telephone set for manual service
as described in the appropriate section on
telephone set connections.
4. Fasten the mounting bracket to the
telephone set housing using two self-tapping
screws. (Fig.
6)
5. Replace the housing per 6.01 B
6. Fasten the NE-95B apparatus blank to the
mounting bracket.
Removal
1. Remove the screw holding the NE-95B
apparatus blank on the mounting bracket.
2. Remove the housing.
3. Remove the mounting bracket from the
housing.
4. Install the dial referring to the applicable
section.
5. Replace the housing.
Page 29