Door Removal / Installation; Glass Media - Napoleon Plazmafire 48 Installation And Operation Manual

fi nishing
EN
4.2

door removal / installation

WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A.
Remove the surround with safety screen.
(see "SURROUND INSTALLATION /
REMOVAL" section).
B.
Remove the 5 screws that secure the
door.
C.
Lift the door up and off.
D.
Reverse steps to reinstall the door and
safety screen with surround.
note:
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and must be installed.
4.3

glass media

WARNING
!
• Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
• Do not change or substitute the glass media material provided with this appliance. If replacing, use only the
replacement glass media available from your authorized dealer/distributer.
• Do not place any media (glass or vermiculite) in or around the pilot opening. This will interfere with the pilot
operation.
Evenly spread the glass media onto the media tray, covering the media tray.
NOTE: Do not place media directly on or over the burner ports.
Glass media over the burner ports may cause a "Puffi ng" sound as well as an undesirable fl ame pattern. To
eliminate this sound, simply push the media away from the burner ports.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
26
W415-1673 / A / 10.07.19