16. Remove adjusting keys and wrenches. Form the GENERAL OPERATIONAL PRECAUTIONS habit of checking to see that keys and adjusting wrenches are removed from the tool before turning WARNING! When using electric tools, basic safety it on. precautions should always be followed to reduce the 17.
Please replace the drill bit after removing dust 3. Rotation only collector (B). This hammer drill can be set to rotation only mode 6. Selecting the driver bit by pussing the push button and turning the change Screw heads or bits will be damaged should an lever to the mark.
NOTE: 1. Mounting The Hitachi Electric Hammer Grease A is of the low CAUTION viscosity type. When the grease is consumed, Be sure to turn power OFF and disconnect the plug purchase from the authorized Hitachi Service from the receptacle.
Page 21
Remove the brush caps and carbon brushes. After replacing the carbon brushes, do not forget to tighten the brush caps properly and install the tail cover. NOTE: Due to HITACHI’s continuing program of research and development, the specifications herein are subject to change without prior notice.