STEELSPAN STORAGE SYSTEM Module 10 Instructions Manual page 5

Fitting Work Bench Top (Laminate)
Position the benchtop on top
of the Horizontal Beams with
the front edge protruding
80mm out the front face of
the beam.
Ensure the Work Bench Top
protrudes 15mm past the rear
Horizontal Beam for the Metal
Pegboard Tool Display to be
positioned on.
Hold plastic angle brackets on
the face of the beam, 100mm in from each side and flush with the underside of
the benchtop. Tek-screw the bracket onto the beam and then use the self-
tapping screws to fix the underside of the laminated benchtop.
Fitting Work Bench Top (Timber):
The Work Bench Top is now position on
top of the Horizontal Beams.
Ensure the Work Bench Top protrudes
15mm past the rear Horizontal Beam for
the Metal Pegboard Tool Display to be
positioned on.
5