Advertisement
MAINTENANCE
6.
Run the Splash Guard under warm water, from any sink faucet. Wipe
away any left over compound residue with a paper towel or cloth.
7.
Reinstall the Splash Guard by snapping it onto the top of the
main motor.
Note: Pull the Splash Guard forward until it snaps into place a
second time.
8.
Install the side panel and screw down the thumbscrews.
9.
Turn on power.
C. How to clean the Cleaner Disc:
The Cleaner Disc must be maintained on a regular basis. You can
identify that the Cleaner Disc needs to be cleaned by seeing a heavy
buildup on the surface.
1.
Use a "Glass Cleaner" (such as Windex) on the surface of the
Cleaner Disc and let it sit for a minute.
2.
Using a paper towel, wipe the buildup off the Cleaner Disc.
Start from the center and work your way out.
3.
Make sure the Cleaner Disc is dry, before use.
4.
Another option is to use a plastic style bristle brush to scrub
the surface.
D. How to clean the Rubber Platter and why:
From time to time the Rubber Platter may become dirty. When this
happens, dust particles can become entrapped in the top surface of
the platter. This causes the surface to become slick. When the Rubber
Platter is slick discs tend to slip on the surface. In worse case scenario,
this slipping could cause a disc to break.
1.
Take any glass cleaner (such as Windex) and spray the Rubber
Platter.
2.
Let the solution sit for about a minute.
3.
Wipe the rubber platter dry with a paper towel.
4.
If slippage continues, replace the Rubber Platter.
OPERATIONS
A. Error Codes:
1.
ES003: Magnetic Switch Sensor is not detecting that the
Platter is in the home position.
2.
EC004: Lift Cam Switch is not detecting that the Lift Cam has
reset back to the home position.
3.
EMC006: The machine is not detecting the proper amount of
amperage on the Main Motor.
4.
RC: Replace all consumables.
5.
Emergency Stop: Emergency Shutdown Mode.
... CONTINUED
B. How much Compound Solution should I use?
VenMill suggests that the entire optical surface of the disc
be covered with the Compound Solution. This will ensure
optimal repair capabilities. To achieve this, place one dab
North, East, South, West and then spread around.
670 Douglas Street | Uxbridge, MA 01569
Toll Free: 866.864.0210 | Tel: 508.278.0091 | Fax: 508.278.0005
VenMill Industries
www.venmill.com
Advertisement
