Table of Contents
Advertisement
There is too much dough left in
the mixing container.
Appliance is noisy.
There is steam coming out of the
unit near the evacuation tube or
pasta disc.
A small amount of flour or water
has come out from the bottom
of the mixing container.
Cannot remove the disc screw.
Cleaning problems -
Disposal:
At the end of the product's life-cycle, it should go directly to a specially adapted waste-recycling centre.
•
This product may not be treated as household waste. Instead it should be handed over to the applicable
collection point for the recycling of electrical and electronic equipment.
•
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for
the environment and human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailed information about the recycling of this product, please contact your local
council office or your household waste disposal service.
Cleaning and storage:
After use, unplug the appliance, wait for unit to shut down completely then remove all accessories. Clean all the
accessories thoroughly with hot soapy water. Thoroughly rinse all flour, pasta and soap from all the parts and allow
to dry completely before storing.
If necessary, the housing body can be cleaned with a slightly moist cloth. Never allow water to seep into the interior
of the unit base.
Store the appliance in a cool and dry place, away from direct sunlight and out of reach of children.
Specifications:
Product Name
Product Model
Rated Voltage
Rated Frequency
Rated Power
Complete another extrude cycle with more time to extrude more pasta.
Use a smaller quantity of flour and water.
The general operation of this unit will create noise, however loud clunks or
thumping are not normal. Turn the unit off and check that the appliance is
assembled correctly.
There may be some hot steam escaping from the tube feed. This is
completely normal.
Do not touch the evacuation tube, screw or pasta disc when hot and
immediately after extrusion.
The metal point on the screw may also be hot after extrusion. Take care
not to handle it when hot.
This is normal as mixing container and evacuation tube are not sealed.
Put the unit in mix mode for a few seconds. This will relieve pressure on
the disc screw and pasta disc.
You will find the parts easier to clean if you leave the
parts to dry in the air for one hour.
Pasta Maker
PM85
220-240V
50Hz
180W
Advertisement
Table of Contents
