Table of Contents
Advertisement
Maintenance, Storage, and Service
Maintenance and Storage Safety
• Always observe safe refueling and fuel handling practic-
es when refueling the unit after transportation or storage.
• Always follow the engine manual instructions for storage
preparations before storing the unit for both short and
long term periods.
• Always follow the engine manual instructions for proper
start-up procedures when returning the unit to service.
• Never store the machine or fuel container inside where
there is an open flame, such as in a water heater. Allow
unit to cool before storing.
• Shut off fuel while storing or transporting. Do not store
fuel near flames or drain indoors.
• Keep all hardware tight and keep all parts in good work-
ing condition. Replace all worn or damaged decals.
• Never tamper with safety devices. Check their proper
operation regularly.
• Disengage spreader spinner, set parking brake, stop
engine and remove key or disconnect spark plug wire.
Wait for all movement to stop before adjusting, cleaning
or repairing.
• Clean grass and debris from moving parts, drives,
mufflers, and engine to prevent fires. Clean up oil or fuel
spillage.
• Let engine cool before storing and do not store near
flame.
• Stop and inspect the equipment if you strike an object.
Repair, if necessary, before restarting.
• Park machine on level ground. Never allow untrained
personnel to service machine.
• Use jack stands to support components when required.
• Carefully release pressure from components with stored
energy.
• Disconnect battery or remove spark plug wire before
making any repairs. Disconnect the negative terminal first
and the positive last. Reconnect positive first and nega-
tive last.
• Keep hands and feet away from moving parts. If possi-
ble, do not make adjustments with the engine running.
• Charge batteries in an open well ventilated area, away
from spark and flames. Unplug charger before con-
necting or disconnecting from battery. Wear protective
clothes and use insulated tools.
• Check brake operation frequently. Adjust and service as
required.
• Use only factory authorized replacement parts when
making repairs.
• Always comply with factory specifications on all settings
and adjustments.
• Only authorized service locations should be utilized for
major service and repair requirements.
• Never attempt to make major repairs on this unit unless
you have been properly trained. Improper service pro-
cedures can result in hazardous operation, equipment
damage and voiding of manufacturer's warranty.
• Units with hydraulic pumps, hoses, or motors: WARN-
ING: Hydraulic fluid escaping under pressure may have
sufficient force to penetrate skin and cause serious injury.
If foreign fluid is injected into the skin it must be surgically
removed within a few hours by a doctor familiar with this
form of injury or gangrene may result. Keep body and
hands away from pin holes or nozzles that eject hydraulic
fluid under high pressure. Use paper or cardboard, and
not hands, to search for leaks. Make sure all hydraulic flu-
id connections are tight and all hydraulic hoses and lines
are in good condition before applying pressure to the
system. If leaks occur, have the unit serviced immediately
by your authorized dealer.
WARNING:
Stored energy device. Improper release of springs can
result in serious personal injury. Springs should be re-
moved by an authorized technician.
• Always disengage the spreader spinner and close the
hopper gate before maintaining or storage.
• Empty the fertilizer hopper before lifting or tilting the
machine for maintenance or storage.
Periodic Service Intervals
Daily Inspections:
• Check engine oil level. See the Engine Owner's Manual.
• Check the air filter. See the Engine Owner's Manual.
• Spray the shaft bushing in the bottom of the hopper with
a light oil lubricant such as WD-40.
• Check the entire machine for loose hardware or oth-
er problems. Resolve any issues before operating the
machine.
21
Hide quick links:
Advertisement
Table of Contents
