Toro 136-4360 Installation Instructions page 2

Figure 1
1. Bolt—existing hardware
2. Use 4 bolts (M10 x 30 mm) and 4 spring-coil washers to
secure the rear skid plate to the mount plate
Figure 2
1. Bolt (M10 x30 mm)
2. Spring-coil washer
3. Remove 2 bolts from the axle caps on both sides of the
machine (Figure 3).
g204660
2. Washer—existing
hardware
(Figure
g204659
3. Rear skid plate
1. Bolt
2. Axle cap
2).
4. Use 2 hex-socket screws and 2 lock washers to secure
the outer-rear skid plates to the axle caps on both sides
of the machine
1. Hex-socket screw
2. Lock washer
2
Figure 3
Right Side Shown
3. Axle
(Figure 4).
Figure 4
Right Side Shown
3. Outer-rear skid plate
4. Axle cap
g207711
g204658