Advertisement
SOLAR RAIL LIGHT– 7"
MODEL: LL-SRL-7-S-WBA
NOTE: Gently start the screws to ensure
the threads catch. You may also turn
them in reverse and then forward to
catch the threads safely.
5
Place the cover in position and use the provided 5 screws to
secure the cover to the light fixture. Tighten them loosely
first then tighten them fully.
Power Setting
100%
80%
65%
50%
35%
20%
OFF
Holding for 5-seconds
7
* Note: Run times will vary significantly based on
factors such as; Sun Exposure, Season, Geographic
Location, Shading, Installed Location/Position, Battery
Condition, Brightness Setting, etc... The following run
times should only be used as a general reference and
are not guaranteed. Consider your local environment.
* Run Times
6-8 hrs
7-9 hrs
10-12 hrs
13-14 hrs
15-17hrs
17-22 hrs
OFF
Changes LED color
PO BOX 414
105 W. Simon St.
Laotto, IN 46763
Mount the light to suitable surface edge or corner. Use
6
provided Screws or use your own suitable screws, bolts &
nuts to fit your material and application requirements.
CHANGING BRIGHTNESS LEVELS
Wave the magnet over the solar
panel at night until you find the
activation area which changes
the brightness level.
Make a quick up & down motion
over this area to change between
brightness levels and OFF.
NOTE: moving too slowly may
activate the magnet switch
multiple times going through
multiple levels at once. A quick
motion will help!
CHANGING LED COLORS
Hold the magnet over the
activation area for 5 seconds
until the LED color changes
8
Change brightness/power level at night by waving the
magnet over the solar panel
Holding the magnet for 5-seconds in the activation area
will change to the next LED color. You may then change
between brightness/power levels on that LED color.
Phone: 260-918-2758
Fax:
260-918-3540
E-mail sales@lakelite.com
Example Hand Wood Rail
NEW MAGNET
SWITCH OPERATION
www.lakelite.com
www.solarpilinglites.com
Advertisement
