&Z n = s
Writes phone number string s to NVRAM at
position n (n = 03).
&Z n =L
Writes last executed dial string to NVRAM at
position n ( n = 03).
&Z n ?
Displays the phone number stored at position
n (n = 03).
&ZL?
Displays the last executed dial string.
S-Registers
Default values are appropriate for most users.
The settings are modified with the ATS r = n command,
where r is the number of the S register and n is a
decimal value between 0 and 255 (unless otherwise
stated).
Use ATS r ? to examine the configuration of a
register. For example:
Reg Default
S0
0
S1
0
S2
43
S3
13
S4
10
S5
8
46
Sportster Winmodem 33600 & x2/56K - User's manual
$76"(QWHU
Function
Sets the number of rings on which to answer
in Auto Answer Mode. When set to 0, Auto
Answer is disabled.
Counts and stores the number of rings from
an incoming call. (S0 must be greater than
0).
Stores the ASCII decimal code for the es-
cape code character. Default character is + .
A value of 128 – 255 disables the escape
code. The range of acceptable values is
country-dependent.
Stores the ASCII code for the Carriage
Return character. Valid range is 0–127.
Stores the ASCII decimal code for the Line
Feed character. Valid range is 0–127.
Stores the ASCII decimal code for the Back-
space character. A value of 128255 disables
the Backspace key's delete function.