LG MULTI V B1 Series Installation Manual page 15

WIERED REMOTE CONTROLLER INSTALLATION
• Since the room temperature sensor is in the remote controller, the remote controller box should be installed in a place
away from direct sunlight, high humidity and direct supply of cold air to maintain proper space temperature.
Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation at an average tempera-
ture.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote controller
LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
OP
ING
O SW
AUT
n unit
ratio
Ope 03
Tim Off er 01
On no. Time
Set
no
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED LO JET Defrost Filter Out door Humidify
Time ZONE 1 2 3 4
Timer On Off Operation unit Program set
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
CTI ON
FUN eat
SUB Preh idify
EE D Hea ter Hum doo r
SP AUTO Defr ost Out 4
FAN JET Filte r 2 3
T TE MP MED HI 1
SE m Tem p LO 23
ON Roo ZO NE 21
ATI 19
ER e 17
Tim 15
ram set 13
Prog 11
09
07
05
(1.5meters)
Fig.1 Typical locations for remote controller
yes
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
5feet
Installation
Installation Manual 15