Table of Contents
Advertisement
Installation
INSTALLATION OF REMOTE CONTROL BOX
POINT OF REMOTE CONTROLLER INSTALLATION
• Although the room temperature sensor is in the indoor unit, the remote control box should be installed
in such places away from direct sunlight and high humidity.
INSTALLATION OF THE REMOTE CONTROL BOX
• Select places that is not splashed by water.
• Select control position after receiving customer
approval.
• The room temperature sensor of the thermostat
for temperature control is built in the indoor
unit.
• This remote controller equipped with liquid
crystal display. If this position is higher or
lower, display is difficult to see.
(The standard height is 1.2~1.5m high)
ELECTRICAL WIRING TO THE INDOOR UNIT
If the length of the cord exceeds 50m, use a wire size greater than 0.5mm
DISASSEMBLING OF THE REMOTE CONTROLLER
Lever carefully
the box open
using a screw
driver, etc.
WHEN THE REMOTE CONTROL BOX IS
INSTALLED WITH THE CORD BURIED.
PROCEDURE OF INSTALLATION
1. Fix the under plate on the switch box by
screws(Local supply). In this case, fit the under
plate on the wall, and be careful of deformation.
2. Receive the remote control cord in the switch box.
3. Hook the remote control unit on the under plate.
Face of wall
Upper notch
Under plate
Remote
control unit
Screw
(Local supply)
Remote
control cord
Lower notch
Switch box
(Local supply)
14
14
Indoor Unit
Indoor Unit
Remote controller
CN REMO
The maximum length of the cord is 100m.
Front case
Remote
control
box body
Install the remote control box and cord correctly.
ROUTING OF THE REMOTE CONTROL CORD
• Keep the remote control cord away from the
refrigerant piping and the drain piping.
• To protect the remote control cord from electri-
cal noise, place the cord at least 5cm away
from other power cables. (Audio equipment,
Television set, etc)
• If the remote control cord is secured to a wall,
provide a trap at the top of the cord to prevent
water droplets from running.
(Main board)
CN REMO
Make sure that wire and terminal
numbers are matched on unit side
and remote controller side.
2
.
WHEN THE REMOTE CONTROL BOX IS INSTALLED
WITH THE CORD EXPOSED.
PROCEDURE OF INSTALLATION
1. Fix the under plate on the wall by self tapping screws
2. Make a slit (Part A) at the top side of the remote control
box by nipper.
3. Rout the cord as shown in the following figure. In this
case, push the cord into the around of case(Part B).
4. Hook the remote control unit on the under plate.
Remote
control cord
(Part A)
Remote
control unit
FIXING OF REMOTE
CONTROL CORD
1. Fix the cord clamps on the wall
by ø3 tapping screws(Local supply).
2. Fix the remote control cord.
Face of wall
Upper notch
Under plate
Tapping screw
(Local supply)
Upper flange
Push hand
(Part B)
Lower notch
Cord
clamp
Advertisement
Table of Contents
