Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L-B200 and is the answer not in the manual?

Questions and answers

Summary of Contents for Dato L-B200

  • Page 2 Contents 1,Production description 2,Preparing for installation 3,Door lock installation 4,Lock settings 5,Trouble shooting 6,Specifications Production description...
  • Page 3 Preparing for installation 1,Checking the delivery set 2,Installation tools: a M4 Phillips screwdriver if mounting holes are ready. 3.Inspection of door specifications a,Door Thickness: 30~53mm. b,Door lock mounting hole diameter range(single round hole):50-55mm c,Distance from the center of the lock mounting hole to the door profile (60 or 70mm)
  • Page 4 d,Confirm the door opening direction (leftward or rightward, inward or outward)
  • Page 5 Door lock installation 1,Latch Bolt Installation: a, Adjust the Latch bolt according to the distance between the center of the keyhole and the edge of the door(60mm or 70mm); b, Determine the orientation of the latch bolt plane according to the door opening direction. (Refer to Article 3 of Chapter Preparing for installation) 2,Handle adjustment: a, Leftward and rightward opening adjustment: adjust the limit card screws to the position limiting the...
  • Page 6 3,Install the batteries into the front handle The batteries are positioned on the handle of the front panel,please loosen screws and install according...
  • Page 7 to the positive and negative directions of the battery cover with correspondence to the positive and negative directions of the batteries. Please refer to the figure above for details. 4,Install the spindle to the front handle, use the spike fix the spindle on the clutch,bending its pin prevents disengagement, and adjust the direction of fixing spike according to the door opening direction (Refer to picture in article 2 of this Chapter) 5,Pass the front handle through the installed latch bolt, with three holes pined and attention to the...
  • Page 8 6,Testing the fundamental functions: when the external handle is pressed, the door shall be tightly locked without the fingerprint input for identification; when any fingerprint is input for identification with further press to the external handle, the door shall be open successfully( only the recorded fingerprint is allowed to unlock the door after the fingerprint setting) 7, Finish the installation:insert the rear handle from the other side of the door by aligning the quad slot with the spindle(remember to put the rubber pad in advance), and tighten and secure with two mounting...
  • Page 9 4, Emergency Mechanical Key for Unlocking Insert the mechanical key and turn counterclockwise about 45 degrees to open the door Note: please take good care of the mechanical key, which is a necessary accessory for emergency opening and setting management. Trouble shooting Q: No action or abnormal action found after the installation A: Check the battery installation direction and battery power for appropriateness, B.
  • Page 10 Mechanical key to trigger setting switch by 15-degree clockwise switching Low voltage warning 4.8v, Red LED with 5 continuous flashes Dato AI Technology Corporation Address:40 Wall Street, Suite 3302, New York, 10005 Website: www.datoaihome.com Email: service@datoiot.com Customer Support: 929-336-6777, 917-262-0479...

Table of Contents