Grizzly G0895 Owner's Manual page 37

Surfacing
The G0895 can be used to surface a spoilboard
or workpiece, using the mill plane feature and
an appropriate cutter (see Choosing Cutter on
Page 30).
Items Needed
Spoilboard Cutter or Fly Cutter ........................ 1
To surface using the mill plane operation:
1. Hold down RUN/PAUSE, press HIGH/LOW,
then release both buttons at the same time to
open advanced processing menu.
2. Scroll to "Mill plane" and press OK.
3. Choose "Scan mill" or "Encircle mill" and
press OK. A list of operation parameters will
appear.
Note: A "Scan mill" operation runs back and
forth from one end of the defined workpiece
to the other. An "Encircle mill" operation runs
from the outside to the inside of the defined
workpiece.
Model G0895 (Mfd. Since 01/20)
4. Define operation parameters. Press RUN/
PAUSE to change a parameter and OK to
save. Distances are measured in millimeters.
— Scan Type changes the direction of the
operation. For scan milling, "X Scan"
runs back and forth across the X-axis,
Qty
and "Y Scan" runs back and forth across
the Y-axis. For encircle milling, "AC" runs
counterclockwise around the workpiece
and "C" runs clockwise around the
workpiece.
— Height and Width defines the size of the
area to be surfaced.
— Diameter defines the diameter of the sur-
facing tool used.
— Depth defines the total depth of material
removed.
— Z Step defines how much material is
removed per pass. For example, a Depth
of 1 and Z Step of 0.25 would remove
1mm of material over four passes.
— TRatio defines the stepover, which is the
amount of overlap the cutting tool makes
per pass.
5. Press OK after all parameters have been
saved to start the mill plane operation.
-35-