Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0895 (Mfd. Since 01/20)
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Designs/writes G-code that defines toolpath.
2.
Uploads G-code to USB drive.
3.
Examines workpiece to make sure it is suit-
able for cutting.
4.
Installs appropriate cutter for type of material
and operation.
5.
If necessary, cuts workpiece with table saw
or other machine to fit within working enve-
lope of this machine.
6.
Secures workpiece to table. If using vacuum
table, turns vacuum pump ON.
7.
Turns machine ON.
8.
Homes all axes and verifies parameters (see
Page 28).
9.
Connects USB drive to hand-held controller.
10. Sets work origin. Sets Z-axis relative to
workpiece or table, depending on toolpath
requirements.
11. Connects dust shoe and dust collection sys-
tem to spindle.
12. Puts on safety glasses, respirator, and hear-
ing protection.
13. Turns dust collection system ON.
14. Runs G-code. Spindle will automatically start
and follow toolpath.
15. When toolpath is complete, spindle will stop
and return to position defined by G-code.
-29-
Advertisement
Table of Contents
