Advertisement
Mode
Setting
Footswitch Modes (on SPEED knob):
SPEED
Short footswitch press = toggle Bypass on/off
(factory setting).
Holding the switch longer than 1 sec = activate
1
Speed2 as long as the switch is being held
(momentary switching)
SPEED
Same as Mode1, but speed switching is
latched (button can be released).
2
SPEED
Short footswitch press = toggle Speed1 / 2.
Holding the switch longer than 1.5 sec =
Bypass off. Switching the effect ON is
3
immediate and does not require holding the
switch.
SPEED
This mode is useful when the micro Vent is
used with a true bypass switcher. The effect is
always on and the Bypass switch is only used
4
to activate Speed2. Speed switching is
momentary, thus Speed2 is only active as long
as the footswitch is pressed.
SPEED
Same as Mode 4, but Speed switching is
latched, not momentary.
5
Mode
Setting
Output Level Trim (on BLEND knob):
BLEND
Use the entire pot travel to set a level
between-3dB and 0dB.
Min setting: -3dB, Max setting 0dB (factory
setting)
Other Functions - The unit remembers its last Bypass and Speed
state on power up. It also remembers the last Speed state in
Bypass, if Switch Mode 2 or 3 is selected.
Pedalboard order - Best to place the micro Vent before Reverb
and Delay. Then try it after Drive for an intense rotary experience
or before Drive for a more subtle sound that isn't as prominent.
WARRANTY TERMS
Neo Instruments extends a warranty covering all verifiable defects
in material and workmanship for a period of 12 months from the
date of original purchase. Statutory warranty rights remain
unaffected. The warranty covers the remedying of manifest defects
by replacing or repairing defective parts. Any other claims, in
particular those for a reduction in price or cancellation of contract,
may only be made after an attempt to rectify the defect or deliver a
replacement has failed.
The warranty does not cover damage incurred during transit, as
well as damage caused by non-compliance with the operating
manual and improper or negligent handling of the device. Beyond
that, the warranty does not cover defects or damage caused by
acts of God (including but not limited to lightning, floods, etc.) or
other external influences, as well as mechanical damage or flaws
that are not attributable to manufacturing defects. If defects occur
during the warranty period, please contact us at the following
address:
NEO Instruments
Flemingstrasse 20-22
D-36041 Fulda
+49 (0)661-9619805
info@neo-instruments.de
© 2019 Neo Instruments. All Rights Reserved
Advertisement
