Page 1
This example uses a QM30VT2 with BWA-BK-014. The same steps can be applied for a QM30VT1 with BWA-BK-014 or a QM30VT2-SS-9M with BWA-BK-012. The provided thermal tape or desired epoxy could be used by following these steps. 1. Clean the bracket and sensor.
Page 2
6. Stick the bracket and sensor assembly to equipment. 7. Apply pressure for 30 seconds to improve adhesion. Install the BWA-BK-012 and -014 Using a Flathead Screw This example uses a QM30VT2 with BWA-BK-014 for demonstration. The same steps can be applied for a QM30VT1 with BWA- BK-014 or a QM30VT2-SS-9M with BWA-BK-012.