Advertisement
blending rod.
Note: - Ensure either beaters or dough hooks are fully inserted into the correct sockets or
your mixing results may be affected.
- Only one type of accessory can be used one time.
USING YOUR HAND MIXER
1. With the Speed selector in the "0" position, plug the cord into power outlet.
2. Turn the Speed selector to your desired speed and begin mixing. There are 5 speed
settings to be selected. The appliance will start working and the mixer will run at the
highest speed when pressing turbo button.
Tip: always start mixing at slow speeds and increase the speed gradually to prevent
ingredients splashing out of the mixing bowl， when adding dry ingredients use the lowest
speed to prevent the snow storm effect.
3. For the blending rod, the max operation time per time shall not exceed 1 minutes; the
appliance shall be cooled down before starting the next cycle. For the mixer, the max
operation time per time shall not exceed 4 minutes, and minimum 20 minutes rest time
must be maintained between continuous two cycles.
Note: The max operation time without load for blending rod shall not exceed 15s.
4. When mixing is complete, turn the Speed selector to "0" position and unplug the cord
from power outlet.
5. Scrape the excess food particles from the beaters or dough hooks by rubber or wooden
spatula.
6. To remove the beaters/dough hooks, place fingers loosely around the spindles and
press the Ejector button firmly down. For detaching blending rod, the Ejector button is
inactivated and just turning the blending rod in anticlockwise direction and the door
would be released automatically.
3
Advertisement
