MAGMATIC Prisma Driver 8 User Manual page 12

I N S T A L L A T I O N I N S T R U C T I O N S
PHOENIX CONNECTORS
This driver is compatible for use with the following Magmatic lighting fixtures: Prisma Mini
BAR 20, Prisma Mini PAR 45, and Prisma Mini PAR 20. A set of Phoenix connectors is
included with this driver, and may be used to connect these fixtures to the driver.
Begin by inserting the male end of the Phoenix connector into the desired signal output
port on the driver, making sure that the latch on the Phoenix connector engages with
the signal output port. Tighten the two screws located to each side of the wire terminals,
as highlighted in the image to the above right.
Now insert the wire leads from the fixture into the wire terminals of the Phoenix
connector, making sure that the bare wire lead ends have been fitted with wire end
sheaths. Tighten the two screws above the wire terminals, as shown in the image at
above right, to secure the wire leads in the Phoenix connector.
12