elero AeroControl Manual

AeroControl/AeroControl-868
GB
The control unit for sun protection systems
General:
The awning controller is a control unit for sun protection systems
(awnings/venetian blinds).
It controls the system connected according to light intensity and
wind strength.
The wind alarm and its signal have precedence over the light
sensor.
The AeroControl-868 controller contains a radio receiver module
set at 868.3 MHz.
Hinweis: Beachten Sie die ESO-Vorschriften.
Connection diagram
AeroControl 28 370.0101
AeroControl-868 28 370.0001
LED green
Radio programming
mode and wind alarm
Exceedance of wind value
Receiver module 868.8 MHz
17 700.6001
3 1 2
1
Aero
2
3
Awning control
Markisensteuerung 28 370.0001
3 1 2 3
Li Wi
3
2
Ventero 1
1
2
Aero
3
Jalousietaster
Redeployment after wind alarm
ON ON Venetian blind
Learn Test
DIP
1 1 Awning
LED yellow red No redeployment after wind alarm
Exceedance of light value
max.
min.
Wind Light
3 N L N
Mains
230VZ
PE (lloose terminal)
M
1Z
Awning control
3 1 2 3
N L N N
Net
N
M
M
L
N L N
PE
1Z 1Z
Netz
N
L
PE
PE (lose Klemme)
M
Important safety indications!
Observe the following Instructions.
Danger of injury due to electric shocks.
Connections to the 230 V mains supply must be carried
Warning!
out by authorized, specialized personnel.
• Check the installations regularly for wear and tear or
damage.
• The regulations stipulated by the local power supply
company should be observed during connection
work, as well as the regulations for wet and damp
areas in accordance with VDE 0100.
• Observe country-specific regulations.
• Only use unaltered elero original parts.
• Ensure that nobody is within the vicinity of the
installation until it is brought to a standstill.
• When carrying out work on the installation
(e.g. maintenance), always disconnect the installation
from the mains supply.
• Keep children away from controls.
• After installation, the control unit must not be
exposed to rain.
Connection options:
Aero, Ventero, Lumero,
Mains lead,
1 alternating current drive,
Momentary contact switch
Note: Connect the protective earth to the accompanying
terminal block.
You can connect a maximum of 4 AeroControls per
wind sensor.
Awning control
L N 3 1 2 3 N L N
Net
N
M
L
PE
1Z
Operation via:
Momentary contact switch or
hand-held transmitter
(only for AeroControl-868)
Awning control
3
1 2 3 N L N
Net Net
N N
M
L L
PE PE
1Z