Operating Elements And Connections; Setup; Filling Up Fog Fluid; Placing The Unit - EuroLite N-130 Tour Fogger User Manual

Hide thumbs

Table of Contents

Available languages

Filling up fog fluid

Fluid handling

Always disconnect from the mains before filling the machine. Only use water-based fluids. We

recommend high-quality Eurolite fluids. Never add flammable liquids. If fluid gets inside the machine,

have it checked by skilled personnel before it is operated.

Unscrew the tank cap and fill the tank with fog fluid. Tightly close the tank again.

Placing the unit

• Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the fog

output nozzle.

• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a

condensation of the fog fluid. The resulting slippery surface can cause accidents.

• To prevent overheating the device, ensure that the ventilation slits are not covered and that air can circulate

freely.

• Keep a minimum distance of 20 cm around and above the device.

• Only install the fog machine on scratch resistant and water resistant surfaces (inclination angle max. 15°).

• Do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to create a good

effect, there should be a distance between the device and the audience of at least 1.5 m.

• All fog machines develop condensation around the output nozzle. Because this may result in some moisture

accumulation on the surface below the output nozzle, consider this condensation when installing your unit.