Specification
Dimensions
(excluding bracket)
Weight
Display
Power requirements
Controls
Audio indications
Battery Replacement
For optimal performance, batteries should be replaced on an annual basis.
If the Apgar timer is to be removed from service or stored, the batteries must be
removed.
The LCD flashing between the messages "Lo" and "Batt" indicates a low
battery condition, when this message appears, the batteries should be
replaced at the earliest opportunity.
To replace the batteries, remove the mounting bracket from the rear of the
timer using a 3/16
release the battery cover. Remove the existing batteries and insert new ones (4 x AA/
LR6/MN1500 1.5V Alkaline), observing the correct polarity.
Depleted batteries should be disposed of as per local regulations.
Routine Maintenance
It is recommended that the Apgar timer be checked at least annually to
ensure correct performance.
Perform service checks as detailed on the Service Sheet overleaf. There
are no user serviceable parts inside: if the device does not meet the
specification please return it to Viamed for repair.
142 mm (W) x 130 mm (H) x 40 mm (D)
551g
4 digit LCD display. Digit height: 25 mm.
4 x AA/LR6/MN1500 1.5 V Alkaline Batteries
Start, Freeze/Unfreeze, Reset
1, 5, 10 minutes
inch Allen Key, then using a narrow blade screwdriver
th
Operator Manual's - Digital Apgar Timer
Need help?
Do you have a question about the Apgar Timer and is the answer not in the manual?