INSTALLATION
Installing the Fireplace Screen.
1. Insert each rod through the rings located at the top of the screen. NOTE: Before placing
the last ring over the rod, slide the tinnerman clip (included in the parts bag) onto the rod
and then slide the last ring over the rod. (See Figure 5)
2. Insert the right screen and rod into the hole in the side trim and line up rod with the back
hole in the firebox top and fasten with one of the 5/16" head screws included.
3. Now insert the left screen and rod as above. (Figure 5)
TINNERMAN
CLIP
RING
SCREEN
Installing the Fireplace Hood.
1. Slide the Hood over the shoulder screws and gentle press down until secure. NOTE:
There are (2) shoulder screws on each side of the firebox opening directly below the
top plate. These shoulder screws should line up with the notches on the sides of the
Fireplace Hood. (See Figure 6)
12
CONTINUED
HOLE FOR ROD
ROD
Figure 5 - Installing Fireplace Screen
SHOULDER SCREW
HOOD CUT-AWAY
TO SHOW
UNDERSIDE
Figure 6 - Installing the Fireplace Hood.
SCREW