Related Manuals for Politec ALES QUAD Series
Summary of Contents for Politec ALES QUAD Series
- Page 1 PRODUCT ALES QUAD Product code ALES QUAD 160 ALES QUAD 250 ALES QUAD QUADRUPLE OPTIC PERIMETER BARRIER INSTALLATION AND MOUNTING MANUAL VERSION 1.2...
-
Page 2: Table Of Contents
11.2 Basic settings and programming - AQ BASE RX board 11.2 Basic settings and programming - AQ BASE TX board 11.3 Heater connections - AHTR 12. Intervention time adjustment ……………………………………………………………………………………..…….…..20 13. Technical specifications………………………………………………………………………………………………….……………..21 14. FAQ ..............................22 15. Product disposal ……………………………………………. ………………………………………………………..….……...23 ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 3: Introduction
The system has been designed to detect intrusions and activate the alarm; it is not a device that prevents intrusion.Politec is not responsible for damage, injury or loss caused by accidents, theft, force majeure (including momentary lightning-induced overcurrent), abuse, improper or incorrect use, faulty installation or inadequate maintenance. -
Page 4: General Warnings
• Manufacturer's liability:Politec assumes no liability for failures resulting from incorrect installation; lack of maintenance, incorrect assembly or use. • Politec is also not liable for incorrect or incomplete operation of the product or failure to detect intrusion. •... -
Page 5: List Of Main Components
(present on AQ250) Board cover Gasket Optics unit Fixing plate stopper Dis.TRG dual optics Base Ales Quad 5 / 8 ATMP Concentric stopper Board Wall fixing plate Concentric gasket U-shaped brackets for pole fixing ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 6: Preparation For Installation
• Check that the surface chosen for the installation of the product is sturdy so as to ensure stable fixing and that it is adequately protected against possible impacts or the elements. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 7: Examples Of Mounting/Fixing
Pole mounting with Wall mounting with Wall mounting with wall brackets plus U- wall brackets wall brackets shaped brackets appropriate spacers (recommended long wall protection sections) ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 8: Placement And Mounting
• Loosen the plate locking screw and remove it by sliding the plate down against the aluminium profile of the barrier WARNING: Product warranty is invalid if there is any hole in the aluminium profile or any component ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 9: Evaluations Before Installation
TX and RX, thereby ensuring a good amount of signal constantly, even in case of particular climatic conditions. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 10: Barrier Positioning
DO NOT place barriers close to roads: vehicle lights directed towards the RX could create disturbances DO NOT place barriers near automatic gates: photocell signals can create interference. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 11: Wiring
The LAR22 can power up to 8 ALES QUAD barriers.The LAR22 container is metallic, so it must be placed inside a room or put in a watertight container if used outdoors.A battery up to 18Ah can be housed in the container. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 12: Connection Of Cables From Power Supply To Barrier
Power supply Power supply Power supply ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 13: Connection For Wired Synchronism
N.B.:In case of optical synchronism, the receiver must not get IR signals from other sources (photocells, other IR barriers etc.) Sout ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 14: Barrier Alignment
It is sufficient to apply the filter only on the TX, there is no need to repeat the operation also on the RX. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 15: Alignment
The maximum alignment condition will be reached when the high-intensity LEDs are on steady and the buzzer will emit a continuous sound, for this reason, it may be necessary to make minor adjustments also on the RX optic. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... - Page 16 TRANSMITTER optic with your hand: if the RECEIVER continues to give a continuous beep, it means that it sees another infrared source that must be turned off and eliminated. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2...
-
Page 17: Basic Functions
Slow O.C. fog disqualification signal output:NO to GND ALM / ALM NC alarm output TMP / TMP NC tamper output 24V / 24V Heater power supply GND / 12V 12V power supply ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 18: Basic Settings And Programming - Aq Base Tx Board
Sin - / Sin + Output synchronism Sout - / Sout + Not in use TMP / TMP NC tamper output 24V / 24V Heater power supply GND / 12V 12V power supply ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 19: Heater Connections - Ahtr
AQ 160 version, in this case, connect the AHTR board with the cable provided and fix it at the bottom to each TX and RX column, using the screws supplied. N.B.:The jumpers must be positioned on 24V or 12V depending on the type of power supplied for the heaters only ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 20: Intervention Time Adjustment
Working with 2 beams, the barrier must be installed at a height greater than 70cm from the ground to effectively detect a person running ALARM ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 21: Technical Specifications
STANDARD MODELS:ALES QUAD 160m – ALES QUAD 250m Total beams 2TX + 2RX Power supply 12-24Vdc Consumption 50 mA 25W 24V - 12V ac/dc Heaters in column with thermostat (optional on AQ 160) ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 22: Faq
(gate photocells, other barriers, infrared etc.) Use the shielded cable for separate power supply and synchronism by connecting the braid to the earth; Check the sizing of the power cables; ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... -
Page 23: Product Disposal
Warning!- Local regulations can impose heavy penalties for incorrect disposal of these products. ALES QUAD POLITEC | INSTALLATION MANUAL - VER.1.2... - Page 24 For technical support, contact your security systems distributor POLITEC | INSTALLATION MANUAL - VER.1.2...
Need help?
Do you have a question about the ALES QUAD Series and is the answer not in the manual?
Questions and answers