Installation; Specifications - Tripp Lite MTB3-DOCK-01 Owner's Manual

Installation

Notes:
• See Optional Accessories section for suggested cables.
• When the unit is connected to the Thunderbolt 3 port on your computer and to a
network via Cat5e/6 cabling, a network connection will automatically be established.
If no connection is made, one can be established manually by going to your
computer's network settings page. For example, when using a Mac, navigate to the
Network section found in System Preferences, click the 'Assist Me' button to open
the Network Setup Assistant, then follow the prompts to establish a connection.
• Both HDMI and DisplayPort monitors can be connected at the same time for
transmitting 4K video to two displays at once.
1. Connect the built-in Thunderbolt 3 USB-C cable to the Thunderbolt 3 port
on your laptop, tablet or other device.
2. Use an HDMI cable to connect a monitor or display to the unit's HDMI
port.
3. Use a DisplayPort cable to connect a monitor or display to the unit's
DisplayPort.
4. Connect a USB peripheral to the unit's USB-A port.
5. For an Ethernet connection, use Cat5e/6 UTP cable to connect to the
unit's RJ45 port.

Specifications

Input Connector
Thunderbolt 3
Output Connectors
USB-A
DisplayPort
HDMI
Ethernet
Environmental
Operating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
USB-C (Male)
USB-A (Female)
DisplayPort (Female)
HDMI (Female)
RJ45 (Female)
32° to 104°F (0° to 40°C)
10% to 85% RH, Non-Condensing
-4° to 185°F (-20° to 85°C)
5% to 90% RH, Non-Condensing
4