Motorola Symbol STB20 Series Quick Reference Manual page 9

Quick Reference Guide
Mark the surface through the three holes on the bottom of the cradle, or use
6.
the mounting template to determine the location of the screw holes.
Pre-drill holes to accommodate three 1.5" #8 Phillips
7.
Attach the cradle securely to the surface.
8.
Place the scanner in the cradle.
9.
Mounting the STB2000-F on the Forklift
Consult an environmental health and safety
10.
manager to determine an appropriate
mounting location within the recommended
15" reach envelope.
Ensure the converter knob is in the correct
11.
position (see
Caution on page
Attach the host and power cables to the
12.
appropriate ports (see
7).
Position the cradle with the screw holes in the
13.
cradle aligning with the holes in the isolators.
Attach the cradle to the bracket using three
14.
8-32 x 1.5" Phillips screws through the cradle
and isolator holes.
Mark the mounting surface through the four
15.
screw holes on the mounting bracket, or use
the mounting template to determine the
location of the screw holes.
Pre-drill holes into the mounting surface to
16.
accommodate four 1/4-20, minimum 1.0"
length, Phillips head screws.
If desired, thread cable ties through the holes
17.
on each side of the bracket and secure the
host and power cables along the edges of the
bracket.
Attach the bracket to the mounting surface.
18.
Place the scanner in the cradle (see
19.
the Scanner in the Cradle on page
DRAFT
6).
Connections on page
Inserting
10).
9
head screws.
???
Reach Envelope
15" Radius
Side View, Seated
15" Radius
Top View
15" Radius
Side View, Standing