Lost Connection To Host; Charging The Scanner Battery In The Cradle - Motorola Symbol STB20 Series Quick Reference Manual

Quick Reference Guide

Lost Connection to Host

If scanned data does not transmit to the cradle's host, ensure that all cables are
firmly inserted and the power supply is connected to an appropriate AC outlet, if
applicable. If scanned data still does not transmit to the host, reestablish a
connection with the host:
Disconnect the power supply from the cradle.
1.
Disconnect the host interface cable from the cradle.
2.
Wait three seconds.
3.
Reconnect the host interface cable to the cradle.
4.
Reconnect the power supply to the cradle, if required.
5.
Reestablish pairing with the cradle by scanning the pairing bar code.
6.
NOTE
The Symbol STB3578 does not always require a power supply, depending on
the host interface.

Charging the Scanner Battery in the Cradle

To charge the scanner battery, place the scanner in the cradle (see
Cradle). The battery begins charging when the scanner LED
Scanner in the
indicator starts flashing green. A complete charge of a fully discharged battery can
take up to four hours using external power and up to 10 hours using the interface
cable.
Scanner LED Indicators
The green LED on the scanner indicates charging activity (see the table below). If
the scanner is charging in fast mode (non-bus powered mode), the green LED
blinks at a fast rate. If the scanner is charging in slow mode (bus-powered mode),
the LED blinks at a slow rate.
If the red LED on the scanner begins flashing, indicating a charging problem,
remove the scanner from the cradle and replace the battery. If the red LED on the
scanner continues flashing, contact a Motorola Enterprise Mobility business
Support Center.
Standard Scanner Use LED Sequences
Off
Slow Blinking Green
Solid
DRAFT
???
Scanner not in cradle; scanner not placed correctly; cradle is
not powered, or environment is outside the battery charging
temperature range.
Scanner is charging.
Charging complete.
11
Inserting the