Cleaning Build Plate; Moving Axes - Grizzly G0923 Owner's Manual

Cleaning Build Plate

After printing, clean build plate to ensure it does
not attract debris. Accumulation of dust and fila-
ment residue on the build plate prevents printed
layer from adhering evenly.
Dried glue can be scraped off using a flat edged
tool such as a putty knife. Alternatively, run build
plate under warm water until glue softens and
rinses off. Dry build plate before use.

Moving Axes

Sometimes it is necessary to move the axes to a
location other than home. All axes can be moved
through the command interface. The X and Y
axes can also be moved by releasing stepper
torque and moving them manually.
Moving Axes via Command Interface
1.
Press control dial to open main menu.
2.
Select "Prepare," then "Move axis." Axis
select menu will open (see Figure 39).
Figure 39. Axis select menu.
Note: Extruder (E-axis) will not move unless
nozzle is preheated.
-30-
3. Select axis to move. Axis movement menu
will open (see Figure 40).
Figure 40. Axis movement menu.
4. Select increment of movement. Axis move-
ment screen will open (see Figure 41).
Figure 41. Axis movement screen.
5. Rotate control dial to change axis position.
Note: Position shown on axis movement screen is
based on position when printer was last homed. If
axis has not been homed since machine powered
on, it is possible to run steppers beyond soft limits.
Although this is unlikely to damage the machine, it
should be avoided when possible.
Model G0923 (Mfd. Since 05/20)