Standard Fittings; Installation - bar Comet AX Series Assembly, Operation And Maintenance Instructions

WARNING
• This part of the manual is dedicated to Skilled Technicians and is not intended for users of the machine in
which the pump is integrated.
WARNING
• During unpacking, always wear gloves and protective eyewear, to prevent injuring hands and eyes.
• Some pumps are heavy components (also refer to the
are therefore best unpacked by cutting away the bottom of the cardboard box.
• The packaging elements (plastic bags, staples, etc.) must not be left within reach of children as they represent
potential hazard sources.
• Packaging components must be disposed of according to the regulations in force in the country where the
machine in which the pump is integrated has been manufactured.
Plastic packaging must not be discarded in the environment.
• After unpacking the pump, make sure no parts are missing and that all parts are in perfect condition, and that
the identification plate is in place and legible.
In case of any doubt, do not install the pump, but contact the Manufacturer or a Skilled Technician.
• This manual and the warranty certificate must always accompany the machine in which the pump is integrated
and made available to the end user.
Make sure the purchased product consists of the following elements:
• pump;
• oil cap with vent (8);
• pump manual;
• declaration of incorporation;
• warranty certificate.
In case of problems, contact the Manufacturer or a Skilled Technician.
WARNING
• The Skilled Technician must abide by the installation instructions contained in this manual, in particular, the
specifications of the motor (electric or internal combustion), to be coupled to the pump must be in conformity
with the constructive performance and specifications of the pump (power, rotation speed, flanging, etc.), as
shown on the Manufacturer's technical documentation.
• The machine in which the pump is integrated must be made in such a way as to ensure conformity with
the safety requirements indicated in the European Directives. This fact is guaranteed by
by the Declaration of Conformity of the Manufacturer of the machine in which the pump is integrated.
• The pump must be installed and allowed to operate horizontally (for any exceptions in merit, contact the
Manufacturer).
• The pump must be stably fastened.
• Being of the positive-displacement type, the pump must always be equipped with a pressure unloader/regulation
valve (such valve is already built in the pump marked by the letter K preceded by a dash and in the AX and BX
series pumps).
PART TWO
(for Skilled Technicians only)
UNPACKING
"s
peciFications and technical data

STANDARD FITTINGS

INSTALLATION

" paragraph) and these
markings and
EN
31