Polaroid iZone iE877 User Manual page 14

You can purchase the iE877 waterproof casing for underwater action and added durability.
Waterproof case sold separately. To assemble your camera to the case, follow the instructions
below:
1. Before placing the camera into the waterproof casing and before capturing your images:
- Power on you camera.
- Select the camera mode and settings as desired.
- Set the zoom as desired.
2. To open the case: Insert a finger at the half circle of the latch by prying the latch up - away
from the case.
3. Insert the camera lens forward into the case.
4. Before sealing the waterproof casing, make sure the camera housing's rubber seal clean.
Close the door and secure the latch.
5. While the camera is in the waterproof casing, press the SHUTTER button for recording
your videos and capturing your photos.
To continue capturing images when the camera powers off while in the casing, please
remove the camera from the casing and power on the camera. Then return the camera to
the casing, close the casing securely and continue capturing your images.
Note:
 Make sure to power on the camera and set the desired camera settings before inserting the
camera into the case. If the camera powers off while in the case, please remove the camera
from the case, power on the camera, and then return the camera to the case.
 A single hair or grain of sand can cause a leak. You can test by closing the case without
inserting the camera. Submerse the case completely in water for about a minute. Remove the
case from the water, dry off its exterior with a towel, and then open the case. If the entire
interior is dry, the case is safe for use under water.
 Before opening the waterproof casing and putting the device in, carefully check whether the
waterproof ring of the casing is flat and smooth.
 After placing the device into the waterproof casing and closing the cover, carefully check
whether the waterproof ring is deformed due to pressure.
 After every use in salt water you will need to rinse the outside of the housing with non-salt
13