Maximal current *, A 155х40х55 Maximal dimensions, mm Number of cards More than 500 Lifetime, years * - values mentioned at a nominal supply voltage The manufacturer reserves the right to change the packaging, specifications and appearance without notice Praktika K-01 card collector...
4. Product design Fig 1. General view of card collector The housing is made of brushed stainless steel. In front of the housing there is a hatch with lock for quick access to collected cards and to the board where PS, OD and ACS cables are connected. The hatch includes a card storage device.
Page 8
3 days. Before startup, the card collector must be kept in a room with normal climate conditions for 12 hours after storage in unheated rooms. Dimensions of container - 345x345x1095 mm (HxWxL). Praktika K-01 card collector...
6. Safety requirements CAUTION! Failure to comply with the safety requirements specified in this section may result in damage to human life and health, total or partial loss of workability of products and (or) auxiliary equipment. CAUTION! Installation of the card collector shall be performed by qualified personnel according to the instructions.
When the passage is performed or the specified time interval is expired card collector switches into standby mode and can collect the next card. Green arrow turns on on the LED panel, indicating the authorization of the passage. Praktika K-01 card collector...
Page 11
Passage with guest cards Guest card shall be inserted into the card hole up to the stop otherwise it will be ignored. In case the presented card is authorized, the card collector collects it and then unlocks OD for 5 seconds. Storage device is full When the storage device is overfilled, the card collector stops collecting guest cards and provides four short audio signals at intervals of...
7.4. Inversion of LED panel board In some cases, for correct display modes of the card reader, you need to invert the board indicating by 180º depending on the installation site. Inversion is made according to the Installation guidelines (section 6). Praktika K-01 card collector...
Page 14
Appendix 1. Typical faults Fig 3. Location of optocouplers of card collector Praktika K-01 card collector...
Page 15
Table 1. Troubleshooting Fault Possible causes Actions PS unit is connected, but the Check the connection cable; Check the fuse on board the card reader; card collector does not work Storage device is Act in accordance with Section 7.3; full Check the condition of the cables and connectors;...
Page 16
2. IR LED3 (Vtyp = 1,2 B): - If V = 5 V - LED or cable defective; Act in accordance with Section 7.2, "Emergency mode"; Card or foreign object is left in card hole of card Card collector provides 5 collector audio signals, red cross on the LED panel is blinking...
Page 17
- If V = 5 V - phototransistor or cable are defective...
Need help?
Do you have a question about the Praktika K-01 and is the answer not in the manual?
Questions and answers