BENDIX TABS-6 Service Data page 12

Diagnostic Trouble Codes
1st 2nd Diagnostic Trouble Code (DTC)
Digit Digit
SAL Sensor configuration error
4 6
SAR Sensor configuration error
5 6
6 1 Over-voltage
6 2 Low-voltage
6 3 Excessive power line resistance
7 1 MOD1 Hold solenoid shorted or open
MOD1 Release solenoid shorted or
7 2
open
8 1 MOD2 Hold solenoid shorted or open
9 1 MOD3 Hold solenoid shorted or open
MOD2 Release solenoid shorted or
8 2
open
9 2 MOD3 Release solenoid shorted
7 3 MOD1 ABS modulator dynamic error
8 3 MOD2 ABS modulator dynamic error
9 3 MOD3 ABS modulator dynamic error
MOD2 Valve configuration error
8 4
MOD3 Valve configuration error
9 4
Valve MOD1/2 low-side switch shorted
10 1
to ground
Valve MOD3 low-side switch shorted
10 2
to ground
ABS modulator dynamic error - all
10 3
valves
10 4 Excessive ABS activity
11 1 ECU internal error
ECU configuration error
11 2
12
J1587
Description
ELECTRONIC CONTROL UNIT (ECU)
J1587
(SID) (FMI)
Verify correct ABS configuration using blink codes or other
•
3 13
diagnostic tools.
If needed, reset to the default ABS configuration and power-up
•
4 13
to initiate auto-configuration.
POWER
251 3
• Power supply diagnostic trouble code. Go to Section F,
251 4
page 30.
251 13
MODULATOR (MOD)
3, 4,
42 5, 6
or 12 •
Clear DTCs.
• If DTCs return, replace the Bendix
3, 4,
48 5, 6
or 12
43
44
3, 4,
5, 6
or 12
49
50
7
8 7
9
Verify correct ABS configuration using blink codes or other
•
8 13
diagnostic tools.
If needed, reset to the default ABS configuration and power-up
•
9 13
to initiate auto-configuration.
COMMON
• Check for corroded/damaged wiring or connectors between
the ECU and MOD.
7
• At the MOD harness connector, verify:
4
• No continuity from modulator/AUX leads to ground.
• After repairs or if no issues found, then clear DTCs.
9
• If DTCs return, replace the Bendix
7 Dynamic ABS Modulator DTC. Go to Section H, on Page 32.
7
Dynamic Wheel Speed Sensor DTC. Go to Section G, on
1
Page 31.
• Check for damaged or corroded connectors.
• Check for damaged wiring.
254 12
• After repairs or if no issues found, then clear DTCs.
• If DTCs return, replace the Bendix TABS-6 module.
• Verify correct ABS configuration using blink codes,
PC-diagnostics or other off-board diagnostic tools.
254 13
If needed, reset to the default ABS configuration and power-up
•
to initiate auto-configuration.
(DTCs)
(continued)
Repair Information
TABS-6
®
Static ABS Modulator DTC.
Go to Section H, on Page 32.
Dynamic ABS Modulator DTC.
Go to Section H, on Page 32.
TABS-6
®
module.
™
module.
™