Uniden DSS7955+1 Series Owner's Manual page 71

Symptom
Can't make or receive calls.
The handset doesn't ring or
receive a page.
Severe noise interference.
The Caller ID does not
display.
You cannot register the
handset at the base.
The handset doesn't
communicate with other
handsets.
• Make sure that you are not too far from the base.
• Make sure the line is not in use. If an outside call is already using a line, you
cannot use that line to make another outside call.
• Check both ends of the base telephone line cord.
• Make sure the AC adaptor is plugged into the base and wall outlet.
• Disconnect the AC adaptor and reconnect.
• Change the Digital Security Code (see page 69).
• Make sure that you are not too far from the base.
• Charge the battery in the handset for at least 5-20 hours by placing the handset
on the base or charging cradle.
• Change the Digital Security Code (see page 69).
• Keep the handset away from microwave ovens, computers, remote control toys,
wireless microphones, alarm systems, intercoms, room monitors, fluorescent
lights, and electrical appliances.
• Move to another location or turn off the source of interference.
• The call was placed through a switchboard.
• Call your telephone provider to verify your Caller ID service is current. There
may be a problem with your Caller ID service.
• Charge the battery pack in the handset for 5-20 hours.
• Change the Digital Security Code (see page 69).
• Make sure you have not stored 0 handsets already.
• Change the Digital Security Code (see page 69).
• Make sure that you have registered all handsets.
70
Suggestion