Summary of Contents for TASKA Prosthetics Low Profile Wrist
Page 1
do more Low Profile maintenance taskaprosthetics.com and care guide V1.1 10 Nelson Street, Riccarton, Christchurch 8011, New Zealand. EMERGO EUROPE Prinsessegracht 20 2514 AP The Hague Netherlands...
Page 2
1 Low Profile maintenance and care guide Low Profile maintenance and care guide 2 Precision myoelectric Introduction components, designed The TASKA Low Profile Wrist is a lightweight, waterproof alternative & assembled in to the Quick Disconnect Wrist. With a lower build height and a fully New Zealand.
Follow the process as described in the section Lubrication and cleaning later in this guide. It is recommended to clean and lubricate the Low Profile Wrist each time the hand is removed. This must be done at a minimum of once per year to ensure the best performance of the product.
Lubrication and cleaning The lamination process is unique to each prosthesis and will vary depending on the Cleaning and lubricating the running surfaces of the Low Profile Wrist must be local technique used. performed annually, and is recommended each time the hand is removed from the prosthesis after extended use.
Page 6
4. Remove excess dirt and dust from the mechanical surfaces of the Lamination 6. Use the Low Profile Wrist Lubricant to lubricate the bayonet and ball bearing Ring as shown. The features around the ball bearings are difficult to clean.
Page 7
3. Power on the hand and check the sensors are both functional. Power the hand 7. Apply a small amount of Low Profile Wrist Lubricant to the thread of the LP Wrist OFF before continuing.
Page 8
13 Low Profile maintenance and care guide Low Profile maintenance and care guide 14 TASKA Prosthetics, 10 Nelson Street, do more Riccarton, Christchurch 8011, New Zealand.
Need help?
Do you have a question about the Low Profile Wrist and is the answer not in the manual?
Questions and answers