Table of Contents
Advertisement
Duplicate Frequency Alert
If you enter a frequency which has been stored in another channel, you will hear an error
tone and the other channel displays.
Press
(decimal key) to clear and start again.
––– OR –––
Note: Press E again to store the frequency in both channels. The smallest channel
appears on the display when you store same frequency in two or more channels.
Memory Lock
To avoid the accidental programming frequencies and talk group IDs, you can lock the
memory with Memory Lock.
Press and hold PROG for 2 seconds to activate this feature ,and "PROG" appears on
the display. If you press E to program memory, you will hear two beeps. To deactivate
Memory Lock, press and hold PROG for 2 seconds again.
Scanning Private Bank
1. After programming frequencies, simply press
HOLD/RESUME to begin scanning. Or pressing
SCAN repeatedly until "SCAN" appears on the
display, you can start Private Bank Scanning.
The scanner scans only upward all the channels.
2. The bank indicators selected for scanning appear on the display, and the bank being
currently monitored flashes. You can deselect banks from active scanning by entering
their numbers on your keypad. The indicator for each deselected bank disappears, and
the bank's channels are not scanned.
Note: One bank must always be active. You cannot deactivate all five banks at the
same time. If you try to deselect all the banks, the first bank is automatically
selected. To restore a bank to active scanning, enter the bank's number on your
keypad. The bank's indicator will display again.
3. During normal scanning the scanner skips
unprogrammed or locked out channels.
4. When a transmission is received, the scanner stops
on that channel. When the transmission ends,
scanning resumes automatically.
Note: You can set the scanner to hold for two seconds
on the frequency for a response. For more
information on Delay feature, please see page 28.
UBCT9 OM 22
SCAN
SCAN
12/11/07 3:53:40 PM
Hide quick links:
Advertisement
Table of Contents
